Log in

View Full Version : 2 x (6' x 18" x 18") tanks on a stand with divider



OZFISH
Fri Dec 19, 2008, 12:09 AM
Hi Guys, I have this on ebay finishing soon.

http://cgi.ebay.com.au/ws/eBayISAPI.dll?ViewItem&ssPageName=STRK:MESELX:IT&item=180312724181

FISH BREEDING OR HOLDING OR DISPLAY TANKS
2 TANKS BOTH 6 FOOT BY 1.5 X 1.5 FOOT OR 180CM X 45CM X 45CM
Each tank holds approx 365 Litres (730 in total). The bottom tank is separated into 6 1 x 1,5 x 1,5 sections

It is currently separated into 4 x 1 foot and 2 x 1 foot sections. It could be 3 separate sections (2 lots of 1 foot) or 6 x 1 foot sections all filter at once.

The top section is separated into 4 x 1.5foot sections. Currently it is divided into 2 x (2 lots of 1.5 foot). You can either connect these to 2 sumps or even a single sump. You can also use between 2 and 5 canisters depending on your needs.

Also you can use say sponge filters in each section as i did for discus.
The stand is also included and the tanks are drilled for outlet pipes if using a sump. No filters, pumps, heaters or sump included

All lids are included on the tanks. This setup would cost well over $1000 to have made. This is great for Breeding or Display Marine or Freshwater fish. The tank also includes 2 x 6 foot Flouro lights (1 for each tank)

The glass is 6mm and strongly braced. The stand Height is just under 7 foot (204cm)

The tank is Located at ST Marys

Red Tail Shark
Sun Dec 21, 2008, 12:01 PM
did the tanks end up selling

OZFISH
Thu Dec 25, 2008, 02:53 AM
Yep, for just over $250. Soo cheap.