FS: Fish breeding tanks, cabinet and supporting frame in ADL

[tgf]

I have a fish breeding tank setup for sale. In the picture attached, the tank on the floor to the right goes on top of the solid wood frame which is sitting on top of the large cabinet on the left of the photo.

There is a section in the back corner of the higher level tank which allows for a sump and then plumbing down to the lower level tank so you can get a single cannister filter and have the entire setup running off that.

http://imageshack.us/photo/my-images/826/dsc3030w.jpg/

The setup includes the following:
- the dark stained wood cabinet on the left of the photo
- the tank on top of the cabinet in the photo on the left
- the tank on the right of the photo sitting on the floor
- the wooden frame which sits ontop of the lower tank and the cabinet to support the higher tank
- a couple of heaters
- all glass lids for the tanks
- two 6 foot long lights (one for each tank)
- Two large sponge filters
- An automatic fish feeder (runs off AA batteries)

Measurements:

Cabinet: 158cm long - 63cm deep - 80cm high
Wooden stand on top of cabinet: 69cm high
Each of the tanks: 122cm long - 53cm high - 36cm deep

Delivery is possible as long as it's in the metro area of Adelaide. Otherwise pickup in Oakden.

The small fish tank to the right of the large cabinet and next to the shelves is NOT for sale.

PRICE: $400 negotiable

[Nev]

Here's your pic.

[tgf]

Ahhh cool thankyou Nev

[Biological]

Nice setup Nev......

[Biological]

Sorry tgf.....

[tgf]

LOL no worries

[SurferJoe]

I am assuming ( hopefully correctly ) that you have had both tanks full of water on top of the cabinet and it handles the weight OK?

If so might be interested once I do some measurements tomorrow after work - possibility of a delivery to Morphett Vale down south?

Thanks
Mark

[tgf]

To be specific, it had water up until around the middle of September. Simply siphoned (not sure of spelling there) the water out and the fish have moved to a different tank.

With regards to delivery to Morphett Vale yes that's possible but that's a friggin big drive from Oakden...

[tgf]

Hi Mark are you still interested?

[tgf]

OK price dropped to $300